Monday, November 28, 2011

Replacing The LCD on a Acer Aspire One Mini.

This is an instructional taken from that addresses my two day problem. Someone decided to place my darling in a very compromising position on a very windy day. Lo and behold - A screen that looks like it was run over by a Mac truck!!! Thankfully, there are how-to's on replacements. I think I'll give it a whirl.
Before you do any of this, make sure to turn off the computer and remove the battery!
  1. The screen is flanked by 6 rubber tabs which mask the screws which hold the LCD in place, illustrated below. These need to be removed – scraping them off with a flat-head screwdriver or something similar (even your fingernail) will do the trick. Keep these somewhere safe to be reapplied later if you wish.
  2. Now that the screws are exposed they should be removed. Make sure to user a properly sized screwdriver and to apply enough force to ensure you don’t strip the screws. Make sure to keep the screws in a safe place for later use.
  3. The next thing to do is remove the black plastic sheath surrounding the screen (the part with Acer written on it). Pry it from the backing section by inserting a flat-head screwdriver or something similar. It need to be popped out near the bottom (where the screen attaches to the body of the netbook), but should pop right out. Just be careful not to crack the plastic. Once this is removed the LCD screen and its attachments will be exposed.
  4. The LCD is attached by four screw brackets, circled above. Each of these brackets have two screws, and for a bent L-shape. Remove ONLY the screw attached to the actual LCD, leaving the bracket attached to the netbook. Do this for all four brackets. Make sure to keep these screws seperate to those which were around the edge of the plastic as they are a different size.
  5. Now that the screws have been removed the LCD can be lifted off the back plate. This will make it apparent that the LCD is attached by three sets of wires to three plastic clips. These clips, which are shown below, need to be removed. The replacement LCD will have it’s own set of clips which will be attached in the same manner to the wires from the computer.
  6. Now out with the old (LCD) and in with the new! Attach the wires of the new LCD in the same manner that the old was attached, slide it into place, and replace the screws through the side brackets. You can then reattach the plastic edge around the LCD, using a screwdriver to pop the plastic tabs at the bottom into place (see picture below), and replace the six screws around the side. If you have the right sort of glue (Im not sure what this is…) you can reattach the rubber tabs too, but I didn’t bother – I kinda like the look of the visible screws!
  7. Now the new LCD should work! wOOt!

No comments:

Post a Comment

What do you think?

Sue Views